|
A. Outer closure: Black
easy-slip-on vinyl cap with a Teflon*-faced liner
B. Black screw-on
phenolic cap with 18mm hole
C. Teflon*-faced septum
reinforced with nitrile rubber.
D. Glass Bottle
|
How to Use TEDIA
ANHYDROSOLV Solvent Bottle Assembly
1. Remove the outer cap.
2. Fill a dry syringe
with dry inert gas (argon or nitrogen).
3. Pierce the septum with
the syringe. Use fresh locations each time to prolong product quality.
4. Push the gas from the
syringe into the bottle, then slowly withdraw the required amount of solvent.
5. Carefully remove the
syringe from the bottle.
6. Dispense the required
solvent.
7. After each use, put
the outer closure back to further protect the solvent from moisture.
Note: Use smaller
diameter needles to optimize the resealability and prolong the quality of the
residual product in the bottle |
